| 1. | Vertical tracking angle error 垂直循迹误差角 |
| 2. | Tolerancing of bevel gears ; tolerances for shaft angle errors and axes intersection point deviations 伞齿轮啮合公差.第4部分:轴线夹角误差及轴线交叉点偏 |
| 3. | 2 . the factors which cause measurement angle errors are analyzed , and the modifications are studied to use in line extraction algorithm for plane _ plane intersection 2 .分析了靶场试验中引起经纬仪测角误差的各项因素,并研究如何在面面交会方法中进行测角误差修正。 |
| 4. | When the signal of gps is lost for five minutes , the position error is about 1400 meters , its velocity error is about 15m / s and its attitude angle error is about 10 degree 在gps信号丢失5分钟时,位置误差大约为1400米,速度误差大约为15米/秒,姿态角误差大约为10度。 |
| 5. | At the end of the chapter , the output of hrg is used in the simulation . the result indicates that the eular angle error is lower after flp filtering if proper step size is chosen 本文还把半球谐振陀螺实际数据引入该算法的仿真,仿真的结果表明,选择合适的阶数可以使flp滤波后的欧拉角误差小于滤波前。 |
| 6. | The coordination control between the angle error and the ratio error was realized through analyzing the common characteristics between the similar magnetizing current compensation and the anti - turn compensation 通过分析相似电流补偿和反匝数补偿的特点,对电流互感器的比差和角差进行了协调控制,补偿效果明显。 |
| 7. | This controller is designed to stabilize angle error , front error and side error separately based on the kinematic model of the rover . the simulation results show the lunar rover can be stabilized to expected point by our proposed method 以月球车的运动学模型为控制对象,分段镇定月球车的方向角、前向误差和侧向误差,最终使月球车镇定到坐标原点。 |
| 8. | By analyzing the amplitude error due to the nonuniformity in the hemispherical resonator circumferential direction , the mathematical model of measuring angle error is deduced and the way by using software program to compensate the measuring angle error is discussed 分析了谐振子环向不对称造成的振幅误差,并建立了由此引起的测角误差的数学模型,讨论了由软件算法来补偿侧角误差的方法。 |
| 9. | Fourthly , this paper standardizes the linear of the inductance sensor and analyzes its error . then we discuss the angle error of the laser sensor and the datum plane error of the mechanism . finally , the paper gives some advice to improve the mechanism 第四,此外,本文还对电感传感器进行了线性校正及误差分析,讨论了激光传感器倾角误差,并对机械设计中的定位结构进行了误差分析,提出了改进的措施。 |
| 10. | The simulation of the terminal guidance procedure is carried out , and the results verified the conclusion that the interceptor can hit the target directly . at last , the effect of flight path angle error on interception performance is analyzed in detail 在此基础上进行了动能拦截器拦截过程仿真,验证了动能拦截器能够直接碰撞命中弹道导弹的结论,并详细分析了在不同相对距离的初始条件下,航向误差对拦截性能的影响。 |